Potter PFC-7501 - Manual (Page 21)

17
8.1 STOP Stop
At the STOP prompt, press any Select key to exit the PFC-7500 or PFC-7501 panel programmer
function. When selected, the panel performs an internal reset and exits the programmer.
The Stop function clears the panel Status List.
During the Stop function, all keypad displays are momentarily blank for two seconds.
Afterwards, the programming function is terminated and the keypads return to the Status List display.
9.1 SET LOCKOUT CODE Set Lockout Code
Pressing COMMAND at the STOP prompt displays SET LOCKOUT CODE. This feature
allows you to program a special code that is then required to gain access to the panel internal
Programmer through the keypad.
Changing the Lockout Code
You can change this code at any time to any combination of numbers from 3 to 5 digits long
(100 to 65535). Do not use leading zeros for the lockout code.
1. Press any Select key. The display changes to ENTER CODE: -.
2. Enter a 3 to 5-digit code (do not enter a number higher than 65535). Press COMMAND.
3. Enter the new Lockout Code again. Press COMMAND. The keypad display changes to
CODE CHANGED.
Once you change the code, it is important that you write it down somewhere and store it in a
safe place. Lost lockout codes require the panel to be sent back into Potter for repair.
Stop
Set Lockout Code