Potter PFC-7501 - Manual (Page 12)

8
3.19
-
-
FIRST PhONE NO: First Telephone Number
This is the first number the panel dials when sending reports to this receiver. A phone number
can consist of two lines of 16 characters to equal 32 characters. You can program a three second
pause in the dial ing se quence by en tering the let ter P. You can program a dial tone detect by
entering the letter D. These characters are counted as part of the 32 allowable characters.
3.20
-
-
SECOND PhONE NO: Second Telephone Number
When PAGER? is NONE, the panel dials the second number when two successive tries using
the first number have failed. If the panel cannot reach the receiver after two attempts using the
second number, it returns to the first number and makes two additional attempts. A total of ten
dialing attempts are made using the first and second phone num bers. If a second phone number
is not entered, the first phone number is used for all dialing attempts.
Each number can be up to 32 characters in length in cluding any P or D char acters entered for
pause or dial tone detect.
3.21
-
-
PAGER ID NUMBER Pager Identification Number
Enter a pager identification number if your pager uses one. For numeric paging, the panel waits
for nine seconds after dialing the First Phone Number before sending the Pager ID. After the
Pager ID is transmitted, the panel waits another three seconds before sending the actual pager
message containing the panel reports. Program additional three second pauses by entering a
letter P for each pause to add.
Communication