Warning, Danger, Important safety instructions – Oakworks PT Table User Manual
Page 5
Weight Limit: (patient and accessories) 550 lbs. (250 kg) Do not exceed.
The Back Rest and Leg Rest sections are not designed to support the entire weight of the patient. Do not sit on
the Back Rest or Leg rest sections.
Be certain that the table is completely lowered without any tilt being present prior to discharging an ambulatory
patient. The patient may lose balance and fall.
This table is not suitable for use in the presence of flammable anesthetic mixture with air or oxygen or nitrous oxide.
Do not lift table by the table top. This can damage the table.
When lowering the table, make sure there is nothing underneath the table top that can impede motion (like stools, cabi-
nets, accessory parts, cleaners, etc)
Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recom-
mended by the manufacturer.
Close supervision is necessary when this furnishing is used near children or disabled persons.
WARnInG
To reduce the risk of burns, fire, electric shock or injury to persons:
1. Unplug this furnishing from the electrical outlet before cleaning.
2. Unplug from outlet before adding or removing parts.
3. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or
damaged, or dropped into water. Contact Oakworks Customer Service before use.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
DAnGeR
Risk of electric shock - Connect this furnishing to a properly grounded outlet only. See Grounding Instructions in
this manual.
Electrical Shock Hazard. The power supply/control module is located under the table seat. No user serviceable parts
are inside the control box. Refer servicing to qualified personnel. Unplug wall plug prior to contact with any cables
connected to the power supply.
2
IMPORTAnT SAfeTy InSTRUCTIOnS