Oakworks PT Table - Manual (Page 26)

All casters should be locked at all times during use with a patient.
DUAl lOCKInG CASTeRS USe
lOCKInG The CASTeRS
1. Place your shoe on the end of the casters locking tab.
2. Press firmly downward until you here a clicking noise
and the caster is locked.
Un-lOCKInG The CASTeRS
1. Place your shoe on top of the casters locking tab.
2. Press firmly inward and downward until you here a click-
ing noise and the caster is unlocked.
The tables are equipped with two wheels at one end and two self-locking, molded rubber feet at the
other. When ready to move the table, first lower the table to its lowest position. On models with a back
rest, it is recommended to raise the back rest to a high position. Then be sure the power source is
disconnected. Place the cord & all controls out of the way on top of your table before moving the table.
Lay a towel or a cloth down on your table top to protect the surface from any debris from the bottom of your
foot control.
Two people are required to safely move the table. Grasp the table frame securely at the end with
the molded rubber feet. Raise the table to allow the wheels at the foot end to move freely. Bending at
the knees before lifting to prevent back strain or possible injury.
Move the table carefully to the next location, lower the table and release. Check the self-locking
molded rubber feet to be sure they are flat side down. This position “locks” the table and allows sturdy
height adjustments. Place the foot controls in position on the floor. Connect the power cord to the outlet
and test the foot control.
Grasp the
table frame
securely here
at both sides
of the brace.
CAUTIOn
MOvInG The TAble
Before moving any of the Tables, disconnect the power cord from the power outlet. The
table weighs as much as 200 lbs. (91 kg.) Use extreme caution when lifting the table to
move it. Two people are required to move the table safely. DO NOT use the table to
transport a patient.
23
DIReCTIOnS fOR USe