Oakworks ProLuxe Series - Manual (Page 14)

DIRECTIONS
FOR
USE
DIRECTIONS FOR USE
MOVING THE TABLE
Grasp the table frame
securely here at both
sides of the brace.
Before moving any of the
Tables, disconnect the power
cord from the power outlet.
IMPORTANT
Be sure to grasp the frame at
the brace between the two legs
of the frame on the end with
the self-locking molded rub-
ber feet to allow the wheels to
move.
The table is equipped with two wheels at one end and two self-lock-
ing, molded rubber feet at the other. When ready to move the table,
first lower the table to its lowest position. On models with a backrest, it
is recommended to raise the back rest to a high position. Then be
sure the power source is disconnected. Place the cord out of the
way on top of your table before moving the table.
Pick up all controls and lay them on the center of the table. Lay a
towel or a cloth down on your table top to protect the surface from any
debris from the bottom of your foot controls.
Two people are needed to safely move the table. Grasp the table
at the brace between the molded rubber feet at that end of the
table. By grasping the table frame firmly at this point, you can raise
the table to allow the wheels at the foot end to move freely. Use proper
positioning when raising the table by bending at the knees before lifting.
This prevents back strain or possible injury.
The table weighs as much as
175 lbs. Use extreme caution
when lifting the table to move
it. Two people are needed to
move the table safely. Be sure
to bend from the knees to prevent
back strain and possible injury.
DO NOT move the table with
client still on the table.
Move the table carefully to the next location, lower the table and
release. Check the self-locking molded rubber feet to be sure they
are flat side down. This position “locks” the table and allows sturdy
height adjustments. Place the foot controls in position on the floor.
Connect the power cord to the outlet and test the foot controls.
CAUTION
WARNING
A more convenient way to move the table from room to room
(without a patient) is with the dual caster option. Unlock the four
casters and maneuver the table to your desired location. The table
can be pushed from either end. Make sure to lock at least one caster
from each side prior to use by a patient. The Dual Caster option
was designed to enable small table positioning with the patient still
on the table, but do not attempt to move the patient from room to
room while on the table.
OPTIONAL DUAL CASTERS
unlocked
locked
11