Oakworks ProLuxe Series - Manual (Page 13)

Back Rest
Control
To Raise the Back Rest:
Raise the back rest by pressing the lever under the head section and lifting up to the desired height. It is
recommended that the client take some weight off the back rest while you lift.
To Lower the Back Rest:
Press the lever under the head section and push the back rest down. Release the lever and the back rest
will stay in place.
To Change Position of the Back Rest Lever:
The back rest lever can be moved to the opposite side of the back rest by removing the screws and
relocating the hand lever to the opposite side of the top into the four pre-drilled holes.
BACK REST
To Raise the Leg Rest:
Raise the leg rest by pulling the lever on the side of the leg section and raise to the desired height.
It is recommended that the client take some weight off the leg rest while you lift.
To Lower the Leg Rest:
Pull the lever on the side of the leg section and push the leg section down. Release the lever once leg
rest is at desired location and the leg section will stay in place.
To Change Position of the Leg Rest Lever:
The leg rest lever can be moved to the opposite side of the table. First, remove the screws from the
lever and replace just the screws. Move lever to the opposite side of the table. Remove the screws that
are there and install the lever.
LEG REST
Leg Rest
Lever
10
DIRECTIONS FOR USE
DIRECTIONS
FOR
USE
OPERATING THE MANUAL TOP
(GAS ASSIST BACKREST & GAS ASSIST SALON TOPS)