Oakworks Clodagh Libra - Manual (Page 17)

14
DIreCTIoNS for USe
To maintain your pedicure sink and its pipeless jets at maximum level of hygiene, thoroughly clean
the tub shell and jets after each use with a nonabrasive antibacterial cleaner, rinse thoroughly and
dry completely. NEVER use abrasive cleaners on any part of the appliance.
Disassembly & initial cleaning
a. Turn pedicure sink off by rotating the control button. Drain the foot bath according to
draining procedure.
b. Remove both jet assemblies. To remove each jet assembly from its casing. Rotate the jet
assembly counterclockwise and pull outward.
c. Remove white impeller cap & impeller.
d. Spray the jet Assembly pieces, foot bath interior and jet cases with *cleaner/disinfectant.
e. Use a clean cloth to clean the jet assembly pieces, removing any visible soil.
f. Scrub all surfaces of the foot bath and jet cases.
g. Rinse all surfaces with tap water
Disinfection & re-assembly
a. Spray the jet assembly pieces, jet cases and foot bath until thoroughly wet with *cleaner/
disinfectant and allow then to set for one minute.
b. Rinse disinfectant from all surfaces.
c. Dry the jet assembly pieces, jet cases and the foot bath with a clean cloth.
d. Reassemble jet assemblies and
reinsert them into jet cases, rotate
them in a clockwise manner to
secure them into position.
Recommended disinfectants
The use of an EPA registered cleaner/disinfectant with tuberculocidal, germicidal, pseudomo-
nacidal, Fungicidal and Virucidal efficacy is recommended. Do not use abrasive cleaners on the
Pedicure Basin or Jet Assemblies. *DISPATCH ® Hospital Cleaner Disinfectant with Bleach is a
suitable cleaner disinfectant for use with the above procedure.
Dispatch ® - EPA Reg. No. 56392-7; EST. No. 62801-MI-001.
Kills bacteria and viruses in 1 minute and TB in 30 seconds.
CleaNING The fooT baTh
e. Rotate tabs until they latch, they must be
latched for the pumps to work. There are
two at 180º from each other.