Oakworks Clodagh Libra - Manual (Page 11)

When moving the table, place one person at each corner of the table. Have each person firmly grasp
the base at the bottom and lift the table. Be aware and use proper, safe procedures for moving a table
of this size to prevent injury to yourself or the table. We strongly recommend that a flatbed dolly be
used that can hold the entire table when moving the table long distances.
CaUTIoN
MovING The Table
Before moving the table, disconnect the power cord from the power outlet. The table
weighs as much as 342 lbs. (155 kg.) Never lift the table by grasping the table top. You
could damage the table and the electronics that run the tabletop. Four people are required
to move the table safely. Do not use the table to transport a patient.
8
DIreCTIoNS for USe
Grasp at
base corner
at low height range
9/16” Open
end Wrench
Leveler Foot
1. Place the table in the location where
you plan to use it.
2. Rock the table to determine if it is
level with the floor. If the table rocks
back and forth at all, the foot that clears
the floor when you rock the table will
need adjustment.
3. Adjust the Leveler Foot by first loos-
ening the locking nut found just above
the Leveler Foot with the open end
wrench.
4. Lower the adjustable Leveler Foot
until it meets the floor snugly. Tighten
the locking nut against the wooden leg
of the table with the open-end wrench
to fix the Leveler Foot in position.
5. Rock the table again to be sure adjust-
ments have stabilized the table. If neces-
sary make any additional adjustments in
the same way.
Tighten Locking Nut Locking Nut
levelING The Table