Oakworks Clodagh Libra - Manual (Page 16)

1.. Fill the unit with water at the desired temperature approximately 2” above the jet cover.
You can fill your sink with:
a. The optional plumbed faucet (if supplied).
b. The supplied fill hose with connector - to attach to a
typical sink spout.
2. To activate or deactivate this appliance, turn the ON/OFF switch to “ON”.
3. Bath additives (including oil based products) can be used in this foot bath, since their residue can be easily cleaned.
CAUTION: Use only low foaming additives.
4. You should always be in a seated position when putting your feet in or removing them from the foot bath.
13
DIreCTIoNS for USe
fooT baTh USe
Risk of accidental injury. Exercise care when entering or exiting of the foot bath. Invalid or disabled
persons should not use the hydro foot bath without trained supervision. Risk of scalding: Water tem-
peratures in excess of 104 º F (38 º C) may be injurious to your health. Check and adjust water temperature before use. Should you
experience any pain or discomfort while using the foot bath, discontinue use immediately and consult your physician. NEVER
STAND IN THE FOOT BATH.
CaUTIoN
supplied fill hose
fIllING The fooT baTh
DraINING The fooT baTh
1. Turn off the foot bath by turning the ON/OFF button to “OFF”.
2. If your pedicure sink is equipped with the optional drain assembly, gently pull up and slightly twist the drain cover to
open. To close the drain, twist the drain cover again and let it drop down and seat itself against the strainer body.
3. If your pedicure sink does not have a drain, place the discharge pump on the flat round surface in the bottom of the
foot bath.
4. Extend the hose connected to the discharge pump to the area where the water is to be drained (sink). Use the suc-
tion cup provided to secure the hose to the side of the sink and turn on the discharge pump by plugging the pump’s
power cord into a GFCI wall outlet. NOTE: This pump must be connected to a GFCI wall outlet for your protec-
tion from electrical shock.
5. When the foot bath appears to be empty, continue running the pump while removing it from the interior of the foot
bath and place it in the sink or chosen draining area. As soon as the pump and hose are both fully in the sink, unplug the
power cord to turn off the discharge pump. Fresh water can be used to rinse out the tank during the draining procedure.
NOTE: Do not leave the pump running in the draining area or in a dry foot bath for more than a few seconds because it
may result in damage to the discharge pump.
attach this end to
your sink spout
place this end
in foot bath
ON / OFF switch
water
discharge
pump