Oakworks Clodagh Libra - Manual (Page 14)

11
DIreCTIoNS for USe
Note: If the leg rest is opening during treatment, it is likely that the leg rests are not closed into the
detent position. Check to be sure there is a gap between the pads when the two sections are put
together. If the pads are too tight, remove the pads, move outward slightly and reattach. (The pads
are held on with Velcro ® . Pull hard and they will come off.
leG reST USe
oPeNING The leG reST
1. With both hands, gently lift the leg rest slightly
and pull outward until it stops.
2. Lower the leg rest until it stops in a vertical posi-
tion beside the foot bath.
3. Repeat for other leg rest.
CloSING The leG reST
1. With both hands, gently lift the leg rest and push
towards the center of the table.
2. Repeat for the other leg rest.
3. Both leg rests will drop into a small “detent”
when fully closed.
CaUTIoN
Maximum Leg Rest load weight: 125 lbs. (57 kg.)
fooT reST USe
The foot rest is designed to store under the foot end of the foot bath as shown.
foot rest
storage
use these
slots for
storage
use these slots when
using foot rest
To use the foot rest - Remove from the storage location, insert in the end rail slot & rotate to horizontal position.