Oakworks Celesta/Clodagh Gemini - Manual (Page 5)

• Electrical Shock Hazard. To reduce the risk of electric shock, always disconnect the table from
the electrical outlet before moving the table or doing any maintenance or troubleshooting proce-
dures.
• The power supply/control module is located at the head end of the table. Refer servicing to qualified
personnel and follow manual instructions when doing any authorized troubleshooting. Before doing any
work on the unit, disconnect the power cord from the power outlet.
• Do not operate the table in standing water.
• Before moving the table, turn accessory controls off, disconnect the power cord from the power outlet and
secure the electrical cord, hand control and foot controls out of the way for moving.
• Use this furnishing only for its intended use as described in these instructions. Do not use attachments not
recommended by the manufacturer.
• Never operate this table if it has a damaged cord or plug., if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
• Keep the cord away from heated surfaces.
• Do not use outdoors.
• Do not operate where aerosol (spray) products are being used or whereoxygen is being administered.
• Risk of Injury — Keep children from moving headrest and foot support. Children should never be near the table
when in use. This table must be locked out (use key lock) and controls stored out of reach if there is any possibility that
children would be near the table when not in use.
• Never drop or insert any object into any opening.
• This product is equipped with an interior accessory outlet. The total electrical load of equipment plugged
into this set of outlets is not to exceed 7 amps or 840 watts. Voltage will be different for other counties.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
DANGER
• Prior to moving the table, bring table top to its lowest position.
• DO NOT sit on the Arm Rests, the elevated Back Rest or Leg Rest.
DO NOT place excess weight on the Side Arm Rests. DO NOT use them in assisting the client on and off the
table.
• DO NOT put excessive weight or pressure on the QuickLock
™ Face Rest. Excessive pressure can cause prema-
ture failure of the QuickLock ™ Face Rest. Do Not extend the dowels of the Face Rest further than 3” from the
table edge to ensure a stable connection.
• DO NOT use the hand control and the foot control simultaneously as this can cause damage to one or both
units.
• DO NOT store or place anything on the cabinet hood under the backrest as this can cause damage to top
•To reduce the risk of electric shock always unplug this table from the electric outlet before
cleaning.
iii