Oakworks Celesta/Clodagh Gemini - Manual (Page 14)

10
DIRECTIONS FOR USE
OPTIONAL ACCESSORY AVAILABLE ON SALON TOP ONLY
Manicure Arm Rests Adjustable Side Arm Rests
1. Insert end of arm rest into
hole in backrest while holding
arm rest at 60° angle.
2. Push end all the way into hole and drop arm rest into horizontal
position. Tug slightly to make sure the armrest is fully locked to
the table (for patient safety).
To remove the arm rest, simply reverse the procedure above.
TO INSTALL THE ARM REST:
The arm rests adjust automatically as the table’s back support moves to remain parallel to the floor in any position.
They are designed to be strong and will take a reasonable amount of weight, but they are not designed to be used to
sustain a person’s weight when getting on or off the table.
The arm rest height is adjusted to level at the factory. When in use, some of
the new parts will wear, and you may see some sagging of the arm rest over
time. If the arm rest is not correct, the height can easily be adjusted using the
enclosed Allen wrench.
1. Loosen bottom 2 set screws
(turn counter-clockwise).
2. Turn side set screw in (clockwise to
rase or counter-clockwise to lower)
while lightly raising the arm rest with
your other hand (to make the adjust-
ment easier).
3. When you have achieved
the desired height, tighten
the two bottom set screws
(turn clockwise).
TO LEVEL THE ARM REST:
ARM REST INSTALLATION AND ADJUSTMENT INSTRUCTIONS
Do not use the arm rest for customer weight support during the mounting or
dismounting of the table. The arm rest is not designed to support the client’s
weight.
CAUTION