Oakworks Celesta/Clodagh Gemini - Manual (Page 13)

The table weighs approximately 300 lbs. (136 kg.) You will need 4 people working together if it is necessary
to move the table. Never lift the table by grasping the table top as the table top is not designed to hold
the weight of the base and you could damage the table and the electronics that run the table top.
If you need to move the table, place one person at each corner of the table. We recommend that you have
the table top in the up position (with Arm Rests removed) to have the table top ends out of the way as
much a possible. Have each person firmly grasp the cabinet base at the bottom by the table legs and lift
the table from the base. As when moving any piece of heavy equipment, bend at the knee and lift with
your legs beneath you and not with your back. Be aware and use proper, safe procedures for moving a
table of this size to prevent injury to yourself or the table. We strongly recommend that a flatbed dolly be
used that can hold the entire table if moving the table involves any large distance.
Grasp
at base
corner Position at low height range
DIRECTIONS FOR USE
MOVING THE TABLE
Before moving the table, disconnect the power cord from the power outlet
and secure the electrical cord, hand control and foot controls for moving.
CAUTION
TABLE EXTENDER
Do not put excessive weight or pressure on the extender.
Excessive pressure can cause premature failure of the Table Extender.
CAUTION
Outlets
The optional stationary Table Extender provides ultimate comfort for your tallest clients, quickly and
easily. The Table Extender comes with two connecting arms that slide into the outlets at the foot end
of the tabletop. Slide these fully into the outlets so the Table Extender is flush to the end of the table
top. This Stationary Extender provides 11” of additional comfort and support when needed.
9