MF Digital Spectrum 2 Thermal - Manual (Page 33)

Spectrum2 Printer Operator’s Guide
Document Revision: 102803
32
• Ribbon can also be wound by
pressing Start and Print buttons
simultaneously
• Ribbon change complete - check
software settings for proper color or
black ribbon selection prior to
printing.
Note:
When installing a mono-color blue or red ribbon, please follow the
instructions below in order to disable the ribbon sensor:
• Press and hold the print button
• Turn on the power to the printer
• Continue to hold the print button down for 25 seconds
• Release the print button when the ribbon spools
• The ready light will come on at this point
• If done improperly, a large amount of ribbon will be spooled and the status
button will blink twice.
• There is no need to enable the ribbon sensor if you want to install a color or
black ribbon. Simply turn the printer off and on again, and the ribbon
sensor will be enabled.