MF Digital Spectrum 2 Thermal User Manual

Page 30

Spectrum2 Printer Operator’s Guide

Document Revision: 102803

Printer Ribbon Installation Chart – Part 1

Remove Cover

• Remove the top cover by carefully

lifting and pulling forward. Remove
used ribbon from printer

Note: Ribbon rollers are held in place
by locking clips secured by
thumbscrews. Loosen but do not
remove thumbscrews to adjust roller
clips.

Load Ribbon Rollers

• Insert the supply ribbon core onto

the silver supply spindle (shown)

• Insert the take up core on to the gray

take up spindle

Note: Ribbon roller has a metal pin that
fits into a notch in the ribbon core.
There are two pin positions for different
length ribbons.

Putting Rollers in printer

• Supply Roller is placed into area at

the front of the printer.

Note: Supply Roller has metal shaft
with square end that fits into square
hole in printer frame

• Take up core is placed in area at in

the middle of the printer.

Note: Take up core Roller has metal
shaft with round end that fits into round

Locking clips