MF Digital Spectrum 2 Thermal - Manual (Page 25)

Spectrum2 Printer Operator’s Guide
Document Revision: 102803
24
This LED indicates error conditions by flashing error codes (See error code list section)
Active LED
This LED lights when printer is processing data or printing
Manual Loading CD Media
Prior to loading the CD
Before manually loading or unloading discs into the Spectrum2, first make sure the
power is on and the ‘Ready’ LED is on. If the CD tray is already extended, a new CD
may be placed with the printable side up on the cushioned surface. If the tray is not
extended, press the ‘Tray’ button to open it. The printable side of the CD surface is
facing up when the stacking ridge near the center edge of the CD is facing down, as
shown below. Please note: DVD media can have a stacking ridge on either side of the
disc.
Figure 6: CD Stacking Ridge.
Loading the CD
Place the CD on the cushioned surface so that
it does not rest on any part of the CD
Positioning Surface or on the centering pin.
(See photo).
When the CD is properly positioned, press the
‘Tray’ button to retract the tray.
Note: When handling CD’s, always grip the
CD by only the center or outer edges. Avoid
touching the flat surfaces of the CD.
Fingerprints on the printable surface of the CD
may make printing inconsistent.
Figure 7: CD Tray open .
Printable Side
Stacking ridge