KERN & SOHN FL 1KG - Manual (Page 5)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.sauter.eu
Instruction Manual
FL
FL-BA-e-1210 5
Figure 8 Diagnostic Menu
If the % offset is between 5% - 10 % please contact your
supplier to arrange a recalibration of your gauge.
If the % offset is greater than 10% please contact your
supplier to arrange for load cell replacement.
These values are given as an indicator only – the need for
calibration / repair may vary according to the individual
characteristics of the load cell.
6) ABOUT
This shows the information of your gauge (Firmware
revision, Model, Capacity, Serial number). To access
ABOUT menu, go to main menu page and press UP and
DOWN to move the cursor point to ABOUT and press
ENTER key the display will show About menu page. Press
ESC key to return to main menu page.
Figure 9 About Menu
11. Measurement practice
For
best measurement accuracy keep the
compression/tension forces in line with the force gauge.
Alleviate bending loads and torque loads applied to the
load cell as these can adversely affect measurement
performance.
Always keep the gauge below the capacity limit shown on
the front of the gauge. If gauge is used above this capacity
in either tension or compression, even for a short time,
permanent load cell damage can result. Overload damage
is not covered by warranty.
12. FL Specifications
Capacity and Divisions
Accuracy: ± 0.2 % of rated capacity
Operating temperature: 60 ºF - 95 ºF (15 ºC - 35 ºC)
Temperature shift at zero load: ± 0.04 % of full-scale/ºC
Output
RS-232 and USB: 8 data bits, 1 Start bit, 1 Stop bit, no
parity
Baud rate: 38400
Peak Capture Rate : 0.100 S
ADC Sampling Rate : 1,000 Hz
13. Conversion Factor