KERN & SOHN TD GOLD 40 - Manual

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-0
Fax: +49-[0]7433-9933-149
Internet: www.sauter.eu
Instruction Manual
TD GOLD 40
TD_GOLD_40-BA-e-1210 1
Operating Instructions
1. Text of the Instruction Manual in HELP Menu
A. Main function of the KERN SSG Software for the
Gold Tester
With this software, the individual ultra sound velocity of
your gold piece can be calculated.
Gold pieces as bars or coins are typically not made of pure
gold with a sound velocity of 3240 meter per seconds
(m/s). Often copper or other components are in small
shares elements of gold pieces. This is necessary to
obtain a better physical characteristics and it needs to be
respected in the check of genuineness.
The components of the mixture of your gold piece can be
taken off the expose that comes with the bar or the coin.
Or it can be asked for at the manufacturer.
B. Start the software
Exctract
KERNSSG.zip
Start
KERNSSG.exe
C. Start of the procedure
Please select „File“ then „New“
D. Choice of the outer appearance
Selection between gold bar or gold coin
E. Weight and Dimensions
Fill in the weight and the dimensions of the piece of gold
(test object)
The following procedure for the measurements is
recommended:
Determination of the weight: Type approved balance, e.g.
KERN KB 650-2NM
* Turn the balance on
* Warm up for approx. 30 minutes
* Place the test object on the weighing pan
* Read the result in grams
Determination of the length dimensions: Caliper, e.g.
SAUTER LC 150
* Take the thickness dimension
* Read the result in millimeters
F. Safety level
Every measurement has its tolerance. A typical tolerance
of e.g. 5% of the measured value represents a safety level