beautypg.com

KERN & SOHN THM 1000N100 User Manual

Instruction manual thm, Sauter gmbh

background image

Sauter GmbH

Ziegelei 1
D-72336 Balingen
E-Mail: [email protected]

Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www. sauter.eu

Instruction Manual

THM

THM-BA-e-1211

1

Thank you for buying a SAUTER test stand. We hope you
are pleased with your high quality test stand with its big
functional range. If you have any queries, wishes or helpful
suggestions, do not hesitate to call our service number.

1.

Included in delivery

-

SAUTER THM

-

Various hooks


2.

Drawing and measures (in mm)



3.

Warning


Intended use
The instrument you have acquired serves to determine the
measuring value of the material to be measured. It is
intended to be used as a “non-automatic“ instrument, i.e.
the material to be measured is manually and carefully

attached at the instrument. The measuring value can be
read off after a stable measuring value has been obtained.


Be careful about the limit load of test stand and force
gauge. Do not go over the maximum force.



4.

Technical Specifications


Capacity: depends on device


Maximum Travel (Y):

200 mm

Travelspeed

depends on device (look on
device label)

Work Voltage

Single phase 110 V

Rate flow

1,5 A

Fuse of main Circuit

3 A

Fuse of control Circuit

0,5 A

Work temperature

10 bis 30 °C



5.

Operation

Turn on the power switch

Adjust the upper and lower limited position block to
suitable position

Choose between

„Spot Motion“ (Manual) und „Continoues

Motion“ (Automatic)

Choose perfect measuring speed with

„Speed dial“.



6.

Attaching of force gauge


With four M 6 Screws








This manual is related to the following products: