KERN & SOHN HK-D - Manual (Page 10)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Instruction Manual
HK-D
HK-D-BA-e-1311 10
6.5.1 Impact direction setting
Press or key to move cursor to the direction
which will be set.
Press 【 ENTER】 key to finish the change.
Press 【 ESC】 key to cancel the change.
6.5.2 Mean times setting
The mean times can be modified in the range of 1～32.
Press number key to input the value, and the cursor can
move in circles to right automatically.
Press 【 ENTER】 key to finish the change. Press
【 ESC】 key to cancel the change.
6.5.3 Material setting
6.5.3.1 Following available materials will be displayed
in case of 【 Hard/
σ
b
】 is set to【 Hard】 :
Press 【 】 or 【 】 key to move cursor to the material
which will be set.
Press 【 ENTER】 key to finish the change.
Press 【 ESC】 key to cancel the change.
Note: 1. After the material setting had been changed,
hardness scale setting will return to HL automatically.
2. Material should be chosen prior to the hardness
scale.
3. The symbol
↓ on the left bottom of menu shows the
menu is not end, which can be paged down by press
【 】 key; The symbol ↑ on the top of menu shows the
menu is not end, which can be paged up by pressing
【 】 .
6.5.3.2 Following available materials will be displayed
in case of 【 Hard/
σ
b
】 is set to【σ
b
】 :
Press 【 】 【 】 key to move cursor to the material
which will be set.
Press 【 ENTER】 key to finish the change.
Press 【 ESC】 key to cancel the change.
Note 1: The symbol
↓ on the left bottom of menu
shows the menu is not end, which can be paged down
by press 【 】 key; The symbol ↑ on the top of menu
shows the menu is not end, which can be paged up by
press 【 】 .
6.5.4 Hardness scale setting
Press 【 】 【 】 or【 】 【 】 key to move cursor
to the hardness scale which will be set.
Press 【 ENTER】 key to finish the change.
Press 【 ESC】 key to cancel the change.
Note:
1. For the current selected impact device and material,
only the hardness scale which can be conversed will
be displayed; hardness which can be conversed will
not be displayed.
2. Material should be chosen prior to the hardness
scale.
3. After the material setting had been changed,
hardness scale setting will return to HL.
6.5.5 Tolerance limit setting
Press number key to input the value, and the cursor can
move in circles to right automatically.
Press 【 ENTER】 key to finish the change.
Press 【 ESC】 key to cancel the change.
Note: 1. If the setting exceeds the measuring range,
the tester will ask operator to reset.
2. Exchanging will be done automatically if the Min.
tolerance limit is more than Max. tolerance limit.