0 table of programming commands, Entraguard bronze, Telephone entry residence guide – Keri Systems EntraGuard Bronze Residence Guide User Manual
Page 9

EntraGuard Bronze
1530 Old Oakland Road, Suite 100
01911-003 Rev. C
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 9 of 14
Telephone Entry
Residence Guide
3.0
Table of Programming Commands
Programming commands can be performed at the EntraGuard Bronze unit or the residence
telephone.
Programming Command
Instructions
Enter Programming Mode
From the Bronze Unit
•
Press .
•
Press
–
the
six-digit
programming code (see page 1 for pre-programmed setting,
the factory default is “999999”).
•
The unit emits a short high-pitched tone to indicate the unit is
in programming mode. If no sound is emitted an invalid
programming code has been entered.
Enter Programming Mode
From the Residence
Telephone
•
Press .
•
Press
–
the
six-digit
programming code (see page 1 for pre-programmed setting,
the factory default is “999999”).
•
The unit emits a short high-pitched tone to indicate the unit is
in programming mode. If no sound is emitted an invalid
programming code has been entered.
All subsequent commands assume the EntraGuard Bronze unit is in Programming Mode.
SET THE
PROGRAMMING MODE
ENTRY CODE
Sets the entry code used to
enter program parameters.
•
Press .
•
Press
–
the
desired
six-digit
programming code (see page 1 for pre-programmed setting,
the factory default is “999999”).
•
Press
. The unit emits a short high-pitched tone to
indicate the entry code has been accepted. A high-low tone is
emitted if an invalid entry code has been entered.