beautypg.com

3 exiting programming mode, 2 set programming mode entry code, Entraguard bronze – Keri Systems EntraGuard Bronze Residence Guide User Manual

Page 7: Telephone entry residence guide

background image

EntraGuard Bronze

1530 Old Oakland Road, Suite 100

01911-003 Rev. C

San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]

Page 7 of 14

Telephone Entry

Residence Guide

2.1.3

Exiting Programming Mode

When programming from the EntraGuard Bronze unit, the unit exits programming mode after 1
minute of keypad inactivity. To exit programming mode immediately after entering a programming

command, press

.

To exit programming mode when using the residence telephone, press

or simply hang up.

2.2

Set Programming Mode Entry Code

To increase system security, you have the option to change the code number required to enter
programming mode from its pre-programmed setting.

NOTE: To ensure the security of your EntraGuard Bronze system, Keri Systems strongly
recommends that you perform this command at any time you feel the Programming Code has been
discovered by someone who should not have it.

This code number must be six-digits long. For security reasons, certain consecutive strings of
numbers are not accepted; for example, “123456” is not accepted. Perform the following to set the
programming mode entry code.

1. Press .

2. Enter the desired six-digit programming mode entry code –

.

3. Press

to lock in the new programming mode entry code. The unit emits a short, high-

pitched tone to indicate the new code has been accepted. The unit emits a short, high-pitched
tone followed by a low-pitched tone if the programming mode entry code has been rejected.

EXAMPLE: Enter the following to set a Programming Mode Entry Code of “135246.”

4. You can now enter another program command or press

to exit programming mode.