Keri Systems EntraGuard Bronze Residence Guide - Manual (Page 11)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-003 Rev. C
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 11 of 14
Telephone Entry
Residence Guide
SET THE RING MODE
Sets the ring pattern used
when a visitor requests entry.
• Press .
• Select the desired ring mode (default = 1).
- Press for three short rings - long pause
- Press for two medium rings - long pause
• Press . The unit emits a short high-pitched tone to
indicate the ring mode has been accepted. A high-low tone is
emitted if an invalid ring mode has been entered.
SET THE MAXIMUM
NUMBER OF RINGS
Sets the maximum number of
rings used when a visitor
requests entry.
• Press .
• Press – the desired number of rings (default = 6).
• Press . The unit emits a short high-pitched tone to
indicate the number of rings has been accepted. A high-low
tone is emitted if an invalid number of rings has been entered.
SET GATE 1 RELAY
ACCESS CODE
Allows a user to activate the
gate 1 relay from the
residence telephone.
• Press .
• Press – the desired relay access code (default = 9).
• Press . The unit emits a short high-pitched tone to
indicate the access code has been accepted. A high-low tone
is emitted if an invalid access code has been entered.
SET GATE 1 RELAY
TIMEOUT
Sets the amount of time the
gate 1 relay is activated.
• Press .
• Press – the desired relay timeout value (default = 5
seconds).
• Press . The unit emits a short high-pitched tone to
indicate the timeout value has been accepted. A high-low
tone is emitted if an invalid timeout value has been entered.
Programming Command Instructions