Keri Systems EntraGuard Bronze Residence Guide - Manual (Page 8)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-003 Rev. C
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 8 of 14
Residence Guide
Telephone Entry
2.3 Program Commands
Once in programming mode, you can change any of the EntraGuard Bronze’s programmable
commands. The general process for changing an existing command value is as follows:
1. Enter the two-digit programming command code for the command you wish to change.
2. If applicable, enter the new value (some commands simply enable or disable a feature and do
not have an associated value).
- If an entry error has been made, press and start again from Step 1.
3. Press to lock in the change.
- If the entry is valid, the unit emits a short, high-pitched tone to indicate the change has been
accepted.
- If the entry is invalid, the unit emits a short, high-pitched tone followed by a low-pitched
tone to indicate the change has been rejected.
4. Return to Step 1 to enter another program command change, or to exit programming mode,
either press or hang up (if using the residence telephone).