Keri Systems EntraGuard Gold Quick Start - Manual (Page 6)

EntraGuard
®
Gold Telephone Entry Controller
1530 Old Oakland Road, Suite 100 01801-001 Rev. 2.2
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 6 of 32
Quick S
tart Guide
EntraGuard
®
– Gold
1.0 Specifications
Unit Dimensions (nominal)
•
11.99 inches high by 8.86 inches wide by 3.8 inches deep, including hinges
• (30.45 cm by 22.5 cm by 9.65 cm)
Operating Temperature/Humidity Range
•
-20°F to 140°F (-29°C to 60°C)
• 0% to 90% Relative Humidity, non-condensing
NOTE: The EntraGuard Gold Heater (P/N 01812-001) is available for extremely cold temperatures.
Controller Power Requirements
•
12 VDC @ 1 A
Current Draw
•
maximum current draw 750 mA for a controller
NOTE: If an electronic locking device (such as a magnetic lock, a door strike, or similar device) is to be driven by the
same power supply as the EntraGuard Gold controller, please ensure the power supply provides enough current to drive
every device connected to that supply plus an adequate safety margin. AC power cannot be used.
NOTE: Isolation of power supplies may be required with high transient situations.
Controller Memory Retention
•
5 year lithium battery back up to support controller RAM and real-time clock
Output Relay Contact Rating
•
1 Amp @ 24 VDC
Input Device Configuration - 3 Inputs
•
Door Sense normally closed
• Request to Exit normally open
• Global Unlock normally open (on master only), or
Auxiliary RTE A-Door normally open
Users Allowed
•
750 tenants maximum
Event Storage Capacity
•
3,640 events
Keypad
•
Alpha Numeric Radiant
• Standard Mechanical
NOTE: When installing the Alpha Numeric Radiant keypad, careful consideration should be given to each location's
ambient lighting. The Radiant keypad may not appear bright enough in direct sunlight. For locations that will be in
prolonged direct sunlight, the Standard Mechanical keypad may be a better choice.