Keri Systems EntraGuard Platinum Quick Start - Manual (Page 9)

EntraGuard
®
Platinum Telephone Entry Controller
Quick Start Guide
Page 9 of 28 P/N: 01969-001 Rev. C
5.3 Connecting a Door Status Input
Each EntraGuard Platinum controller is shipped with an installation kit including all necessary terminal blocks and
transorbs. One of these terminal blocks has a jumper across pins 1 and 2. This terminal block is designated for use on TB-
4. If a door switch is not used on the controller, this jumper prevents a continuous door open status alarm from being
received by the controller. If a door switch is used, simply remove this jumper and install the door switch leads.
Figure 7: Door Status Input Connections
5.4 Connecting a Request to Exit (RTE) Input
Figure 8: Request to Exit Input Connections