Compaq R6000 Series - Manual (Page 30)

Installation 2-5
Compaq Confidential – Need to Know Required
Writer: Dan Lyons Project: Compaq R6000 Series UPS Operation and Reference Guide Comments: revised as per A. May
Part Number: 347223-022 File Name: c-ch2.doc Last Saved On: 3/24/99 1:41 PM
Assembling the Compaq R6000 UPS
Placing UPS in rack.
68-136 kg
150-300 lb
WARNING: This product is heavier than it appears. To reduce the risk
of personal injury or damage to the equipment:
■ Observe local occupational health and safety requirements and
guidelines for manual material handling.
■ Obtain adequate assistance to lift and stabilize the product during
installation or removal. The product will be unstable when not
fastened to the rails.
■ Remove all pluggable power supplies and modules to reduce the
overall weight of the product.
68-136 kg
150-300 lb
WARNING: To reduce the risk of personal injury or damage to the
equipment, take the following precautions when installing the
equipment:
■ The Compaq R6000 UPS and the Extended Runtime Modules
(ERMs) MUST be installed at the bottom of the rack. If placed in
rack with existing equipment, the rack must be re-configured to
allow installation of UPS at the bottom of the rack.
■ The Compaq R6000 UPS must be mounted on the fixed rails
included in the UPS package. Refer to the appropriate installation
card and rack template, also shipped with your Compaq R6000
UPS kit for instructions on rack-mounting the Compaq R6000
UPS.
NOTE: If installing an Extended Runtime Module (ERM) with the Compaq R6000 UPS, the
ERM must be installed at the bottom of the rack, with the UPS immediately above. If the
UPS is installed without an ERM, the UPS must be installed at the bottom of the rack.
After the rails are secured in the rack:
1. With one person on each side of the box, remove the UPS chassis from
the package using the lift-out tray.
2. Gently lower the chassis to the floor in front of the rack.
3. Cut the band that holds the chassis, freeing it from the lift-out tray.
4. With one person on each side, lift the chassis to rail level and slide into
place.