Cabletron Systems SEHI100TX-22 - Manual (Page 74)

Chapter 7: Local Management
7-26 SEHI100TX User’s Guide
PORT SEG. STATUS
Displays the segmentation status of the port selected. The two possible
status messages are Segmented or Unsegmented. The SEHI and SEH
automatically partition problem segments, and reconnect non-problem
segments to the network.
ENABLE PORT
This command lets the user enable the selected port.
DISABLE PORT
This command lets the user Disable the selected port.
UPDATE-FREQ
This command lets the user select the time interval between
Stack/Module/Port counter updates. Choose update intervals in
increments of 3 seconds, with the maximum interval being 99 seconds.
MODULE
This command lets the user view statistics for a selected module in the
stack. The SEHI is Module 1 and each SEH in the stack follows in
sequential order. Figure 7-9 shows each module number in the stack.
Figure 7-9 Module Number Sequence
PORT
Allows the user to view statistics for ports 1–24 of the selected module.
SEH - MODULE 5
SEH - MODULE 4
SEH - MODULE 3
SEH - MODULE 2
SEHI - MODULE 1
1490_28