Cabletron Systems SEHI100TX-22 - Manual (Page 27)

SEHI100TX User’s Guide 4-1
CHAPTER 4
INSTALLATION
This chapter outlines the procedure for attaching the SEHI to the network
as a stackable or standalone device. Ensure that the network meets the
guidelines and requirements outlined in Chapter 3, Installation
Requirements and Specifications, before installing the SEHI.
4.1 UNPACKING THE SEHI
Unpack the SEHI as follows:
1. Remove the shipping material covering the SEHI in the shipping box.
2. Carefully remove the SEHI from the shipping box and set it aside to
prevent damage.
3. Visually inspect the SEHI. If there are any signs of damage, contact
Cabletron Systems Technical Support immediately. Refer to
Section 1.3 for instructions on getting help.
4. Read the SEHI Release Notes included in the shipping box.
NOTE
A single phase grounded power receptacle that meets the
requirements listed in Chapter 3 must be located within seven
feet of the installation.
Failure to follow installation instructions may result in an
electrical shock hazard.
NOTE
Cabletron Systems includes a 3 1/2-inch disk with the
SEHI100TX-22 that contains a backup copy of the FLASH
Firmware Image File. Download the file to the SEHI100TX-22 if
the existing image becomes corrupted. Refer to Appendix B for
detailed download instructions.