Cabletron Systems SEHI100TX-22 - Manual (Page 65)

The Trap Table Screen
SEHI100TX User’s Guide 7-17
SNMP Community Name
Displays the community name included in the trap message sent to the
Network Management Station with the associated IP address.
Traps
Enables transmission of the traps to the network management station with
the associated IP address.
Trap IP Address
Indicates the IP address of the workstation to receive trap alarms from the
SEHI.
7.7.1 Configuring the Trap Table
Use the following steps to configure the Trap Table:
1. Use the arrow keys to highlight the SNMP Community Name field,
then enter the community name.
2. Press ENTER.
3. Use the arrow keys to highlight the Traps field and enter Y to send
alarms from the SEHI to the workstation, or N to prevent alarms from
being sent.
4. Press ENTER.
5. Use the arrow keys to highlight the appropriate Trap IP Address
field.
6. Enter the IP address of the workstation that you want to send traps to
in this field. The format for this entry is XXX.XXX.XXX.XXX, with
the value of XXX ranging from 0 to 255, and three dots, or else it
returns to the beginning of the field.
7. Use the arrow keys to highlight the SAVE option, then press ENTER
or F6. The “SAVED OK” message appears indicating that the changes
have been saved to memory.
NOTE
The first time an attempt is made to exit the screen without
saving the changes, a “NOT SAVED?” message is displayed.
The edits are lost if the user proceeds to exit without saving the
changes.