Cabletron Systems SEHI100TX-22 - Manual (Page 66)

Chapter 7: Local Management
7-18 SEHI100TX User’s Guide
7.7.2 Exiting the Trap Table Screen
Use the following steps to exit the Trap Table screen and return to the
Feature Selection screen:
1. Press the appropriate Function key. To exit to the Feature Selection
screen, use the arrow keys to highlight the RETURN command.
2. Press ENTER. The Feature Selection screen appears.
7.8 THE SNMP TOOLS SCREEN
This section describes how to use the SNMP Tools screen to access
Management Information Bases (MIBs). Access to screen options
depends on the access status accorded to the user’s community name.
This section describes Super-User management capabilities.
SNMP Tools allows access to valuable MIB information. The user gets
information about specific object identifiers (OIDs), edit the values of
configurable OIDs, and request the OID numerically sequential to the
originally requested OID.
Other ways to view OIDs from the SNMP Tools screen include Walking,
Stepping, and Cycling. Walk and Cycle let the user review several OIDs at
a time.
To access the SNMP Tools screen from the Feature Selection screen, use
the arrow keys to highlight the SNMP Tools Support option, then press
ENTER or F9. The SNMP Tools screen shown in Figure 7-7 appears.