Juniper Systems ikeGPS - Manual (Page 6)

Spike Quick Start Guide 6
Aligning the Spike Laser
Before using your Spike, you need to ensure that the laser is aligned with
the camera on your Smartphone.
1 In the Spike app, tap on , then tap Align Laser .
2 Rest your Smartphone on top of a flat, hard
surface, such as a table top. Then hold your
Smartphone vertically and aim it towards two
objects that are at different distances, for
example the edge of a door. Ensure that the
closest object has a vertical edge.
• The distance between the two objects should be
at least 15 feet (5 meters).
• You can use the vertical edge of an open door
and the wall of the room behind it.
3 Slowly move your Smartphone sideways
➊
and check that the distance measurement
➋
changes when the crosshair in the center of
the screen moves on and off the vertical edge.
4 If the measurement changes at the point where
the crosshair moves on and off the vertical
edge, your laser is correctly aligned. If this
does not happen at the correct point, tap on
the left and right blue arrows
➌
to adjust to the
correct point.
5 Turn your Smartphone horizontally
and aiming at the same two objects,
repeat steps 3 and 4 to align the
laser horizontally.
EDGE OF DOOR
9'1"
X: 0 Y: -15
Settings Laser Calibration
➋
Done
X: 5
6'9"
Y: 0
➌ ➌
➊
EDGE OF DOOR
9'1"
X: 0
Y: -15
Settings Laser C
alibr
ation