Juniper Systems ikeGPS - Manual (Page 10)

Spike Quick Start Guide 10
Aligning to the Object
Before you can measure an object, you need to set the surface’s
perspective by outlining a large rectangle on it. This identifies the angle
from which your photo was taken. Your target must be or must contain a
rectangular shape so that the object can be aligned.
1 In the Edit screen, will be
selected by default.
A rectangular shape will appear over
your target.
2 Drag the green circles of the
rectangular shape to align them
to the extreme corners of the
rectangle on your object.
• Here you are simply aligning to the
surface or plane of your object.
You are not measuring your object
precisely unless your object’s shape
fits within the rectangular shape. If it
does fit in the rectangular shape,
then the measurements shown will
be those of your object.
• Use the zoom window to help you
align the green circles precisely to
the corners of your object.
• You may also use your fingers to
Pinch & Zoom on the photo to better
view the object. To enter Pinch
& Zoom mode, the should be
unselected.