Juniper Systems ikeGPS - Manual (Page 15)

Spike Quick Start Guide 15
Compliance
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
Note: The country code selection is for non-US model only and is not available to all US model. Per
FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
ikeGPS Contact Information
350 Interlocken Blvd, Suite 250
Broomfield, CO 80021, USA
office: +1 303 222 3218
42 Adelaide Rd
Wellington, NZ
www.ikegps.com
42 Adelaide Rd
Wellington, NZ
www.ikegps.com
Model:
Spike
Complies with 21 CFR
1040.10 and 1040.11 except
for deviations pursuant to
Laser Notice No. 50,
dated June 24, 2007
Part No.: 940-02000
5VDC 350mA
MADE IN NEW ZEALAND
Contains FCC ID: QOQBLE112
Contains IC: 5123A-BGTBLE112
Disposal of Old Electrical & Electronic Equipment
(Applicable in the European Union)
This symbol on the product or on its packaging indicates that
this product shall not be treated as household waste.
Instead it shall be returned, at no cost to you, to ikeGPS.
By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of
this product. The recycling of materials will help to conserve natural
resources. For more detail on how to recycle your Spike please visit
www.ikegps.com/support and submit a request for collection. ikeGPS
will coordinate the collection of the unit from you with our logistics service
provider at no additional cost to you.