Philips DV900VHS0I - Manual (Page 50)

50 Playing a Disc
DVD AUDIO CD
Playing a DVD or an Audio CD
Before you begin...
Turn on the power of the TV. amplifier and any other equipment
connected to the DVD/VCR. Make sure the TV and the stereo or
amplifier (if applicable) are set to the correct channel. Details are
on pages 8-14.
Press the POWER button to turn on the DVD/VCR. “HELLO”
will appear briefly on the display panel.
Press the DVD/VCR OUTPUT button so that the red
DVD light appears on the front of the DVD/VCR.Then,
pr^ss the DVD button.
3
Press the OPEN/CLOSE button on the front of the
DVD/VCR to open the Disc tray.
Place a Disc into the tray. Make sure the Disc is sitting proper­
ly in the correct recess.
Some DVDs are recorded on both sides. Make sure the side you
want to play is facing up. Or, if the DVD Is recorded on only one
side, place the Disc in the tray with the label facing up.
5
Press the PLAY button. The tray will close automatically, and
playback will begin at the first Chapter or Track of the Disc.
Or, you may press the OPEN/CLOSE button to close the tray, and
DVD playback will start automatically. {You also may close the tray
by gently pressing the Disc tray toward the DVD/VCR.)
If the DVD in the tray has a menu, the menu may appear on the
screen instead. Details are on page 5 /.
With some Audio CDs, playback wilt not begin unless you press
the PLAY button.
6
Press the STOP button to stop playback. If disc playback is
stopped for more than one minute, a screen saver will appear.
Details are on page 77.
Rem em ber, this DVD/VCR
will play only certain Discs.
See page six for details.
3
4
Press the OPEN/CLOSE but­
ton
on the DVD/VCR.
Insert a Disc.
Helpful Hints
A "No Feature" symbol ® moy
appear at the bottom right of the
TV screen.This symbol means either
the feature you tried is not amiable
on the Disc, or the DVD/VCR can
not access the Mature at this time.
This does not indicate a problem
with the DVD/VCR.
If a Disc is dirty or has saatches,
the pictures may appear distorted
and playback may stop. In such
cases, remove the Disc ond turn off
the DVD/VCR. Disconnect the power
cord, then reconnect it Oean the
Disc, then turn on the DVD/VCR
again and reinsert the Disc for play­
back
When the DVD or CD light appears
on the display paiKl, the Disc is
loaded completely and is ready for
playback.
' When you press the OPEN/CLOSE
button or the DVD PLAY button on
the front of the DVD/VCR when the
power is off, the DVD/VCR will turn
on automatically and will be in DVD
mode.