Philips DV900VHS0I - Manual (Page 42)

42 Real-Time Counter Memory
V C R
Follow the steps below to reset the real-time counter to zero at a
tape location you want to refer to later.
Before you begin, place the DVD/VCR in VCR mode.
Press the DVD/VCR OUTPUT button so that the green VCR light
appears on the front of the DVD/VCR.
Press the VCR button, then play, fast forward, or rewind a
tape to the location that you would like to refer to later.
Press the STOP button to stop the tape.
2
Press the DISPLAY/STATUS/EXIT button to see the sta­
tus display.
'STOP
T\^TEREO
I ;08PM
CHIO
3
While the status display is on the screen, press the
CLEAR button to reset the real-time counter to zero.
STOP
TV STEREO 1:08 PM
CHIO
4
5
3
4
While the real-time counter is on the screen, press the
MEMORY button so that M appears beside the counter.
'^STOP
TV STEREO
SLP M 0:00:00
1:08 PM
CHIO
5
To go to a tape location where the real-time counter was
reset to zero, press the REW(ind) button or the F.FWD
button when playback is stopped.
When the tape reaches the point at which the counter was set to
zero, the tape wilt stop.
Press the PLAY button to watch the tape.
Helpful Hints
The MEMORY button does not func­
tion if REPEAT PLAY is set to ON.
Details are on page 41.
To erase a real-time counter memo­
ry, press the MEMORY button until
the /M disappears from the screen.
You may only set the real-time
counter to zero at one location at a
time. If you set the real-time counter
to zero at a second location, the
previous real-time counter to zero
setting will be erased.