Philips DV900VHS0I - Manual (Page 10)

There are two ways to connect your Cable Box/DBS to the DVD/VCR. With this connection:
• You may view any channel.
• You must select channels at the Cable Box/DBS, Channels cannot be changed at the DVD/VCR.
• You may not view a channel other than the one you are recording,
• You may not program channels at the DVD/VCR.
• You can only program a timer recording for one channel at a time. Sec the TV and the DVD/VCR to the Cable
Box/DBS output channel (channel 03 or 04); set the CH3/CH4 switch to the same channel. Set your Cable
Box/DBS to the channel you want to record. When you enter the channel you want to record in a timer
recording, select channel 03 or 04 (the Cable Box/DBS output channel). (This is step S on page 37.) Leave the
Cable Box/DBS on for a timer recording.
10 Hookups With a Cable Box/Direct Broadcast System
Connect a Cable signal to the IN Jack on the Cable Box/DBS.
2
Use an RF coaxial cable (supplied) to connect the OUT Jack on the Cable
Box/DBS to the ANT-IN (Antenna In) Jack on the DVD/VCR.
3
Use a second RF coaxial cable to connect the ANT-OUT (Antenna Out) Jack on
the DVD/VCR to the TV’s ANTENNA IN Jack.
Recording/Viewing Any Channel
With the DVD/VCR on and in VCR position (the VCR light and theVCR/TV light
will appear on the display panel), use the CHANNEL ▲/▼ buttons to set
the DVD/VCR to the Cable Box/DBS output channel (channel 03 or
04). Set the CH3/CH4 switch to the same channel.
2
Set the TV to the same channel to which you set the DVD/VCR.
3
Select the channel you want to view/record at the Cable Box/DBS.