Philips DV900VHS0I - Manual (Page 11)

With this connection:
• You may watch one channel while recording another.
• You may not record scrambled channels.
Hookups With a Cable Box/Direct Broadcast System (cont*d) 11
I
Connect a Cable signal to the DVD/VCR's ANT-IN (Antenna In)
Jack.
2
Use an RF coaxial cable (supplied) to connect the ANT-OUT
(Antenna Out) jack on the DVD/VCR to the IN Jack on the Cable
Box/DBS.
3
Use a second RF coaxial cable to connect the OUT Jack on the
Cable Box/DBS to the ANTENNA IN Jack on the TV,
Recording One Channel/Watching Another
Put the Cable Box/DBS on the same channel as the
DVD/VCR’s CH3/CH4 switch. Set the TV to the Cable
Box/DBS output channel (03 or 04).
Then, with the DVD/VCR in VCR position (the VCR light and the
VCR/TV light will appear on the display panel), use the CHAN­
NEL buttons to select the channel you want to
record at the DVD/VCR. Start the recording.
2
Press the VCR/TV button once to put the DVD/VCR in TV
position. (The VCR/TV light will disappear)
3
Select the channel you want to watch at the Cable
Box/DBS.
When you play a tape, make sure
the Cable Box/DBS is set to the
some channel as the CH3/CH4
switch on the DVD/VCR. Set the TV
to the Cable Box/DBS output
channel (03 or 04).