Automatic operation features 45 – Philips DV900VHS0I User Manual

Page 45

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Automatic Operation Features 45

VCR

The following tape playback features are available in VCR mode.

Automatic Playback

When you put a tape in the DVDA^CR, the power will come on
automatically. If the tapes record tab is missing, playback will begin.
If a timer recording is set, and the TIMER SET light is flashing, the
power wili not come on automatically when you insert a tape with
the record tab intact.
If a timer recording is set and the TIMER SET light is flashing, the
DVDA/CR will eject the tape if the record tab is missing.

Automatic Rewind, Eject

When a tape is played, fast forwarded, or recorded to its end, the

DVDA/CR will rewind the tape, stop, then eject the tape.
If the real-time counter memory is set, the DVDA/CR will only
rewind the tape to the point at which the counter is set to zero,
then stop.The DVDA/CR will not eject the tape automatically. If
REPEAT PLAY is set to ON, the DVD/VCR will not eject the tape

automatically.

Tape Eject

A tape can be ejected with the DVD/VCR power on or off (but the

DVD/VCR must be plugged in).
If a timer recording is set, and the TIMER SET light is on or flashing,
the tape cannot be ejected.To eject the tape, you must first press the

TIMER SET button to cancel the timer recording, then press the

STOP/EJECT button to remove the tape.To reset the timer record
ing, insert a tape, then press the TIMER SET button to put the
DVD/VCR in standby mode for the timer recording.

Automatic Tracking Adjustment

The DVD/VCR adjusts tracking automatically to give you the best
possible picture quality. With some recordings, however, you may get
a better picture using the manual tracking controls (see below).

Manual Tracking

To manually adjust the tracking during normal playback and slow

motion playback, press the CHANNEL

./^ buttons on the

DVD/VCR. (The CHANNEL

buttons on the remote control

will not adjust tracking.)
Tracking will return to Automatic Tracking Adjustment when you
press the STOP button or insert a tape.
You cannot manually adjust the tracking of a Still picture. However,
you may press the CHANNEL buttons on the front of the

DVD/VCR to remove vertical jitter in a Still picture.

Before

Tracking
Adjustment

After
Tracking

Adjustment