Philips DV900VHS0I - Manual (Page 37)

Timer Recording (confd) 37
4
Use the Number buttons (I -8) to select a slot in which to
store the timer recording. There are eight slots. Numbers for open
slots will flash on the screen.
NOTE- If you enter a number for a slot that has already been used to store a
timer recording PREVIOUSLY SET PROGRAM will appear on the screen
briefly. Information about the program in that slot will appear on the screen.
If this happens, press the DISPLAYISTATUSIEXIT button, then select another
number.
5
Use the Number buttons to enter the TV channel you want
to record.
# Cable Users, enter channel numbers as a two-digit number for the
quickest results. For example, to select channel 6, press 0,6. If you
only press the Number 6 button, channel 6 will be selected after a
brief delay. There also may be a brief delay when you select channels
10,^1, and 12. If you want to select channels 100 and above, enter
channel numbers as a three-digit number. For example, to select
channel 117, press 1, 1,7.
• Antenna Users, enter channel numbers as a two-digit number for
the quickest results. For example, to select channel 5, press 0,5. If
you only press the Number 5 button, channel 5 will be selected
after a brief delay.You may only select channels 2-69.
* If you are recording from line input, press OlO to select AV REAR.
• If you are using a Cable Box/DBS, select the Cable Box/DBS out­
put channel (03 or 04). Set the Cable Box/DBS to the channel you
want to record. Leave the Cable Box/DBS on for the timer record­
ing. Details are on page 10.
6
Press two Number buttons for the hour you want the
recording to begin. Press two Number buttons for the
minute you want the recording to begin. Press I for AM or 2
for PM. For example, for 9:30 PM, press 09,30,2.
'ONETIME PROGRAM
PROGRAM I
CHANNEL 10
TIME ON
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
7
Follow the instructions in step
6
to enter the recording’s
stop time. (AM or PM will be set automatically.)
ONETIME PROGRAM
PROGRAM I
CHANNEL 10
TIME ON 09 30 PM
TIME OFF - - : - -
TO CORRECT PUSH CLEAR
. TO END PUSH EXIT
Instructions continue on page 38.
4-7
Helpful Hints
Entries that do not rnotch the
DVDIVCR’s clock or calendar will
cause a question mark to appear
on the screen.
If you are recording from line input,
connect the audio and video cables
to the AUDIO IN and VIDEO IN
jacks on the back of the DVD/VCR
(Please see illustration on page 40.)