Philips FW620C - Manual (Page 8)

BASIC FUNCTIONS
Adjusting the display illumination
To switch on the unit, press POWER ON/STANDBY on the unit or
any sound source button on the unit or on the remote control.
-►The display illumination comes up with full intensity. The
selected sound source is indicated on the display and the be­
longing LED indicator above the sound source button lights up.
• To switch off the unit, press POWER ON/STANDBY on the unit or
on the remote control.
-►The system is in standby mode. The display illumination is half
dimmed and the display shows the day and time.
• To switch off the power suppfy, remove the power plug from
the wall jack.
Notes:
- You can also switch on the set by pressing DISPLAY MODE,
ANALYZER, CLOCK-TIMER, or DEMO.
- The clock memory will be maintained for only ten minutes after
the power supply is switched off.
• You can change the intensity of the display illumination by pressing
BRIGHTNESS.
-►When the system is switched on, the illumination switches
from FULL INTENSITY-HALF INTENSITY-DIMMED-aia...
-► In Standby mode, the illumination switches from
HALF iNTENSiTY-DiMMED-HALF ... When the display is dimmed, the
power input is reduced to about one Watt.
Note: When switching on the system, the display always comes on
with full Intensity.
System display and buttons
When you select a sound source or the clock/timer mode, the
functions available for the chosen source or the clock/timer mode
light up in the display.
By using the ten buttons around the display field, you can select
the desired function. These functions are explained in the
appropriate chapters in detail.