Philips FW620C - Manual (Page 14)

TAPE DECKS
Inserting a tape Fast forward and reverse
m
a
‘S.
tn
1 Press OPEN to open the
cassette compartment.
2 Insert the tape with the open side
down.
-► The display shows uDO.
-*■ The deck detects the presence
of a tape in the cassette
compartment and automatically
selects the tape type (NORMAL or Cr02).
Playing a tape
1 Press TAPE 1 or TAPE 2 on the unit or on the remote control.
-► Briefly TAPE 1 or TAPE 2 appears on the display.
The available display button functions light up:
2 Insert a recorded tape with the open side down.
3 Select the tape side by pressing SIDE on the unit (or on the remote
control) several times until the desired indicator lights up:
-►FRONT: the visible side will be played.
BACK: the invisible backside will be played.
-►The tape counter is set to £?£?£?.
4 If desired, switch on the Dolby NR system by pressing DOLBY NR.
5 Press ► (or PLAY ► on the remote
control) to start playback.
-►The display shows the tape
counter.
6 Press ■ (or STOP ■ on the
remote control) if you want to stop
playback before the end of the
tape.
Notes:
- You can set the tape counter to000 by pressing SIDE twice.
- If no button is pressed for more than 15 minutes after playback
has finished, the system automatically switches off.
nONT
• MUTC
c T n o
' u / Е Б В
mm
« MVri
\ \ 1 p ~i
/ / 1 L 1
During playback
1 Holddown« orM- (or« orw
on the remote control) to find a
particular passage in the forward
or backward direction.
-► The volume is automatically reduced to a low level.
2 Release the button when you have reached the desired passage.
In the stop position
1 Briefly press « or ►►(or« or» on the remote control).
2 Stop forwarding/reversing by pressing ■ (or STOP ■ on the
remote control).
Play mode
You can select the playback mode by pressing PLAY MODE several
times until the desired indicator lights up:
Z to play (record) one side. At the end of the first side the
recorder stops.
ID to play (record) both sides once. At the end of the first
side, the tape direction is reversed and the recorder stops
at the end of the second side.
CD for non-stop playback. The deck reverses the tape
direction (up to ten times) whenever reaching the end of
the tape side. To stop, press ■.
1CZD2 for non-stop playback on both decks: The deck reverses
the tape direction (up to ten times on each deck) when
reaching the end of the tape side. Playback of both tape
sides rotates between deck 1 and deck 2. To stop, press ■.
Note: For a recording only the play modes andD) are
available.
Dolby В Noise Reduction System
The Dolby B NR System is manufactured under license from Dolby
Laboratories Licensing Corporation. The word Dolby and the CO
symbol are trademarks of Dolby Laboratories Licensing Corporation.
' Switch the Dolby B NR on and off with the DOLBY NR button.
Notes:
- A tape recorded with the Dolby B NR system should also be
played In the Dolby B NR mode. If you forget to operate the DOLBY
NR button, the treble may be reproduced too strongly or too faintly.
- Dolby NR button has no influence during dubbing (copying from
TAPE 1 to TAPE 21. An original tape recorded with Dolby B NR
automatically produces a copy with Dolby B NR.
14