Philips FW620C - Manual (Page 11)

TUNER
Programming radio stations (preset stations)
Automatic programming
30 radio stations can be stored automatically in the memory. This
function will clear the old preset numbers. If less than 30 radio
stations are found, the remaining preset numbers will not be
changed.
Manual programming
You can store up till 30 radio stations in the memory.
(A
"o)
c=
Ш
1 Press TUNER on the unit or on the remote control.
2 Press PROGRAM to enter the programming mode.
3 Select the waveband by repeatedly pressing BAND.
4 Press AUTO to start the automatic programming.
-► The available display button functions light up and
AUTO starts flashing:
-► The tuner automatically tunes to stations in the selected
waveband. If less than 30 stations of sufficient strength are
found, the tuner will stop.
-► The last newly stored preset number is automatically tuned in.
' To stop the automatic programming, press AUTO orB.
Note: If you want to maintain some old presets, for example preset
1-9, select preset 10 before starting automatic programming:
now only the presets 10 up to 30 will be programmed.
1 Press TUNER on the unit or on the remote control.
2 Press PROGRAM to enter the programming mode.
-► The available display button functions light up and
PROGRAM starts flashing:
* ГМММ
MffO
о
m m
3 IBO
' t ' ta T » "
nOMAM
СЭ
О
lANO
o> o>
3 Select the desired waveband by repeatedly pressing BAND.
4 Tune to the station to be programmed with TUNING ◄◄ or» (or
■«or» on the remote control), as described earlier.
5 If desired, switch over to FM mono reception by pressing MONO.
6 Press PRESET A or T to allocate a number from 1 to 30 to the
preset station (on the remote control use the buttons M or W or 0-9).
7 Press PROGRAM to confirm the setting.
-►The frequency, preset number and stereo setting are now
entered in the memory.
[Selecting a preset station
Press PRESET A or T until the desired preset number appears on
the display (on the remote control use the buttons M orM or 0-9).
11