Philips FW620C - Manual (Page 19)

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking
the set for repair.
If you are unable to remedy a problem by following these hints,
consult your dealer or service center.
WARNING:
Under no circumstances should you try to repair the set
yourself, as this will invalidate the guarantee.
.2
‘5)
c
LU
PROBLEM POSSIBLE CAUSE REMEDY
No power Power lead is not securely connected. Connect the power lead properly.
No or poor sound VOLUME is not turned up. Turn up the VOLUME.
Speakers are not at all or wrong connected. Check the speaker connections.
Unsuited speakers are used. Use recommended speakers, impedance 6 Ohms.
Badly matching equalizer setting for the given
type of music.
Choose a matching equalizer setting for the
given type of music.
Headphones are connected wrong. Disconnect the headphones.
Reversed left and right sound Speakers are connected. Connect the speaker cables correctly.
System does not react to
operation of any button Electrostatic discharge. Disconnect the set from power supply and
reconnect it after a few seconds.
Poor radio reception FM antenna is not connected. Connect the FM antenna.
Interference caused by the vicinity of electrical
equipment like TVs, video recorders, computers, etc.
Keep the set away from electrical equipment.
The CD skips tracks CD is damaged or dirty. Replace or clean the CD.
Poor tape sound quality Dust and dirt on the heads, capstan or pressure
roller.
Clean the heads, capstan and pressure roller,
see maintenance.
Remote control does not work The distance to the system is too large. Reduce the distance.
Wrong sound source is selected. Select the sound source before pressing the
functional button.
Batteries are incorrectly inserted. Insert the batteries correctly.
Batteries are exhausted. Replace the batteries.
DISPLAY INDICATION POSSIBLE CAUSE REMEDY
fJD SI'BC or CRfJfJDi RCR2 CD is badly scratched or dirty. Replace or clean the CD, see maintenance.
No CD inserted. Insert a CD.
CD inserted upside down. Insert a CD with label upwards.
Laser lens is steamed up. Wait until the lens has acclimated.
IJRORG TRRCK The selected track number does not exist on
this CD or is not included in this program.
Select a correct track number.
NO TOPE No tape inserted. Insert a tape.
TOPE PROTECTE]] Tape is protected against recording. Replace the tape or undo the protection.
RCCQRIINE RCTB'E A recording is active. Stop the recording or wait until it is finished.
EUir NOT POSSIBLE The EDIT CD feature can only be used for
CDs with a maximum of 30 tracks.
Use another CD with less than 30 tracks or
create a program with less than 30 tracks.
19