Setting the timer, Timer operations, O' 'o – Philips - MX3950D User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Timer Operations
Setting the timer
The system can switch on to DISC orTUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
- Before setting the timer, ensure that
the clock is set correctly.
— The volume of the timer will increase
gradually to the last tuned volume level.
If the last tuned volume level is too low,
the set will then increase to a
predetermined minimum audible level*
buttons on
front panel
CtOCK'TSMEFt
DVD system’s
display panel ....
(^ELECT CLCl.^- 0!^
m
CLOOC'HMEft
O' 'O
V ------- / I V ----------
D
■fcpCtC-—
©
O'
r~ S T 'tW
С10СК-Т1Я€Я
i
®
О
IDUB HM
Press
STANDBY ON
to switch on the DVD
system.
Press and hold
CLOCK'TIMER
until
‘SELLTT ELLTK DR riRDi?" appears.
Press (if necessary) to change the display
to ”f IhiER", then press
CLOCK'TIMER
again
to confirm.
Adjust
SOURCE
(or press
DISC/MEDIA
or
TUNER
on the remote) to select the wake up
source (Disc or TUNER,)
Press
to set the wake up time
(minutes and hours.)
To increase the speed, hold down 1'^^ or ►►1.
The changes in minutes will roll over to the
hours.
Press
CLOCK*TIMER
again to store the
setting.
"4- Once the timer is set, it will always switch on
unless you deactivate it.
.1^
icon will remain on the display panel. It
indicates the timer Is activated,
At the preset time, the selected sound
source will play for 30 minutes before it
switches to Eco Power standby mode
(if
no button is being pressed within the time
frame.)
"4-
DISC
- the first track of the last selected disc
will be played, If the last selected disc tray is
empty it will switch to the next available disc. If
ail the disc trays are not available, it will switch
toTuner mode.
"4
TUNER
- the last tuned radio station will be
played.
Repeat steps
of
“Setting the timer."
Press ■ to turn off the timer
^ 0 icon will disappear from the display panel
and “flflDf? DDF" appears.
OR
Press
CLOCK«TIMER
to turn on the timer to
the last setting.
'■4 The timer information will display for a few
seconds, then the system resumes its last active
source or stays in standby mode.
Note:
- The system wiii exit iirrier serting mode jf no
button is pressed within 90 seconds.
36
P
9
001-044_MX39-37-Eng1
2/25/03, 9:59 AM
3139 115 21993