Philips - MX3950D - Manual (Page 34)

Tuner Operations
IMPORTANT!
— Make sure the FM and AM antennas
are connected.
- The TUNING button on the front
panel is used to toggle between
frequency tuning and preset tuning.
When in preset tuning,
“ preset ” appears
on the display panel and / ^^1
buttons on the front panel are used for
preset number selection. Otherwise,
pressing 1-^^ / ►►iwill change the radio
frequency.
Presetting radio stations
You can store up to 40 preset radio stations in
the memory, starting from FM and followed by
AM bands.
Notes:
- The system wiii exit ¡smseWng mode if no
button is pressed within 20 seconds.
- !fno stereo frequency is detected during Plug
and Play. "L"HL" l K HlYfErd'-JR” appears.
Tuning to radio stations
Press TUNER on the remote (or adjust
SOURCE control on front panel) to select
'Ah! rurJEE’'or^'HM fLAtf?."
Press and hold 1-^^ / ►►I on the remote until
the frequency indication starts to change, then
release.
The next radio station will tune automatically
CO lights up for FM stereo reception.
To tune a weak station, press 1-^^ / briefly
and repeatedly until an optimal reception is
found.
Plug and Play allows you to store all available
radio stations automatically.
If you use 1-^^ / on the front panel for
frequency tuning, make sure the system is in
frequency tuning mode. If not, press TUNING.
PRESET will disappean from the display panel.
Connect the system to the power supply
TM'fG IrJSTRLL ..-PFiETT PLPb" appears.
OR
in Eco Power standby/standby mode,
press and hold ►!! on the front panel until
"HUfC ii'JSTRLL ...PF?EbS PLPb" appears.
Press ► H on the front panel to start
installation.
"4 'TPCfFCL fLiR'ER” appears.
'■4 All previously stored radio stations will be
replaced.
Once completed, the last tuned radio station
Will play.
34
pg 001-044_MX39-37-Eng1 2/25/03, 9:59 AM
3139 115 21993