Philips - MX3950D - Manual (Page 18)

Getting Started
Step 1: inserting batteries into
the remote control
Open the battery compartment.
insert two batteries type R06 or AA. following
the indications (H------- ) inside the compartment.
Close the cover
Step 2: Setting the clock
The clock can be set in either 12-hour or
24-hour mode C iiT.'nC HIT or‘'DD-'uu" for
example).
buttons on DVD system's
Aim the remote control directly
at the remote sensor (IR) on the
front panel.
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TV/AVJUNER.)
Then select the desired function
(for example ► I I ► ► ! ) .
&& & I
CD ®
CAUTION!
— Remove batteries if they are
exhausted or if the remote is not to be
used for a long time.
— Do not use old and new or different
types of batteries in combination.
— Batteries contain chemical substances,
so they should be disposed of properly.
Press STANDBY ON to switch on the DVD
system.
Press and hold CLOCK*TIMER until
‘SELTCr ELLTK Ch' ilhldF?" appears.
Press (if necessary) to change the display
to 'LbULk, ", then press CLOCK*TIMER again
to confirm.
Press to set the minutes and hours.
To increase the speed, hold down 1-^^ or
"4 The changes in minutes will roll over to the
hours,
Press PROG to change between 12-hour and
24-hour clock mode.
Press CLOCK*TlMER aga n to store the
setting.
"4- The dock will start working.
To view the clock time in any active
mode
Press CLOCK*TIMER
"4- The dock will display for a few seconds.
Notes:
- If the DVD system is disconnected from the
power supply it will erase the clock setting.
- Ifyou do not press any buttons withm 90
seconds, the system will exit clock setting mode.
18
pg 001-044_MX39-37-Eng1 2/25/03, 10:28 AM
3139 115 21993