IC Realtime 480TVL Super Night Vision Outdoor AF 22X Zoom Camera (ICR200X) - Manual (Page 11)

Speed Dome Camera Instruction Manual 14/57
DIP Switch Setup
Before installing the camera, set up the DIP switch to configure the camera ID and the
communication protocol.
‰
Camera ID Setup
ON
ON
1 2 3 4 5 6 7 8
z ID numbers of cameras are set up with binary numbers.
See the examples shown below.
Pin 1 2 3 4 5 6 7 8
Binary Value 1 2 4 8 16 32 64 128
ex) ID=5 on off on off off off off off
ex) ID=10 off on off on off off off off
z
The camera ID range is “1~255”. Camera ID must not be
“0”!
z The factory default of the camera ID is “1”.
z Match the camera ID with the Cam ID setting of your DVR
or Controller to control the camera.
z If you are connecting a single camera to a controller,
terminate the camera. When connecting more than one
camera to a single controller, terminate the last camera on
the communication line. The last camera means the camera
farthest in cable length from the controller.
z Note that the total length of the communication cable
between a controller and the camera(s) on the same
communication line must be less than 1.2Km.
INSTALLATION
2