IC Realtime 4/8/16/32 Channel 2U Network Video Recorder - Manual (Page 125)

116
Figure 8-42 Detect
Please refer to the following sheet for detailed information.
Parameter Function
Event type Motion detect, video loss and video masking
Channel select the channel to activate recording function
Sensitivity System supports 6 levels. The sixth level has the highest sensitivity.
Enable button Tick to enable
Region
There are PAL22X18/NTSC22X15 small zones.
Blue area is the detection zone. Right click to view in full screen, click OK
before exit to save the setup.
Period Here you can set for business day and non-business day.
Anti-dither Range: 0～600
Alarm output: s. when alarm occurred, system enables peripheral alarm device
Record channel
Select the recording channel (can be selected more than once) , this channel
will be activated to record when alarm occurs.
Send email
System can send out email to alert you when alarm occurs.
Tour Here you can enable tour function when alarm occurs.
PTZ activation
Here you can set PTZ movement when alarm occurs. Such as go to preset,
tour &pattern when there is an alarm.
Capture You need to input capture channel number so that system can backup
snapshot file when alarm occurs.
8.4.2.2 PTZ
PTZ interface is shown as in Figure 8-43
Please note, before operation please make sure you have set speed dome address and the NVR