IC Realtime 4/8 H.264E HD SDI High Definition DVR User Manual

Page 184

174

Parameter

Function

IP Version

There are two options: IPv4 and IPv6. Right now, system
supports these two IP address format and you can access via
them.

MAC Address

The host in the LAN can get a unique MAC address. It is for
you to access in the LAN. It is read-only.

IP Address

Here you can use up/down button (ST) or input the
corresponding number to input IP address. Then you can set
the corresponding subnet mask the default gateway.

Subnet Prefix

The input value ranges from 0 to 128. It is to mark a specified
network MAC address. Usually it includes an organization of
multiple-level.

Default Gateway

Here you can input the default gateway.
Please note system needs to check the validity of all IPv6
addresses. The IP address and the default gateway shall
be in the same IP section. That is to say, the specified
length of the subnet prefix shall have the same string.

TCP Port

Default value is 37777.

HTTP Port

Default value is 554.

UDP Port

Default value is 37778.

Max Connection

Network user max amount. The value ranges from 0 to 20.
O means there is no user can access current device.

PPPoE

Please input the PPPoE user name and password you get from the IPS (internet service provider)
and enable PPPoE function. Please save current setup and then reboot the device to get the
setup activated.

Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN
from the IP address column.
Note:
After PPPoE successful dial, you need to go to the device local end to get device current IP
address and then use the client-end to access this IP address.
Advanced
The advanced interface is shown as in Figure 7-37.

Multiple cast

Please refer to chapter 5.3.5.4 for detailed multiple cast setup information.